Safety & Regulatory Information
- Do not expose your Freedrum sensors to liquid, moisture, humidity, or rain.
- The Freedrum sensors are not waterproof.
- Do not tamper with or abuse the Freedrum sensors. For example, without limitation, do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave, incinerate, paint, or insert foreign objects into the Freedrum sensors.
- Do not use abrasive cleaners to clean your Freedrum sensors.
- Do not expose your Freedrum sensors to extremely high or low temperatures.
- Do not leave your Freedrum sensors in direct sunlight for an extended period of time.
- Do not leave your Freedrum sensors near open flames such as cooking burners.
- Do not dispose of your Freedrum sensors in a fire. The batteries could explode.
- Do not bring your Freedrum sensors into contact with any sharp objects. This can cause scratches and damage.
- Do not insert anything into your Freedrum sensors unless otherwise specified in the user manual. This may damage the internal components.
- Do not attempt to disassemble your Freedrum sensor, it does not contain serviceable components.
- Freedrum has an operating temperature of between 0°C and 35°C.
- Avoid leaving Freedrum in a parked car due the high temperatures that may occur.
FCC Regulatory Statements:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
ISED Regulatory Statements:
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference thatmay cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
- l'appareil ne doit pas produire de brouillage, et
- l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3(B) – This Class B Digital Apparatus Complies with Canadian ICES-003.
Cet Appareil numerique de la classe (B) est conforme a la norme NMB-003 du Canada.
Warning: RF Exposure Compliance
The antenna(s) used for this product must be installed to provide a separation distance of at least 1 cm from all persons.